BLS Polymer Coat No.1 - Directions for use

Shake well before use.
Take 4 to 5 drops on U-Foam pad, rub in circular motion on the color surface.By doing same the oxidized layer on color surface would remove and the major scratches reducing by 60% to 70%.Polymer Coat No.1 would not affect color density. Set machine at Speed No.4. Buff color surface then cleans the color surface by means of 100% cotton cloth.
Rub on steel accessories by Polymer Coat No.1 you can add 3 to 4 drops of water on same U-Foam pad then apply on steel accessories. When the steel accessories goes to dry cleans the steel surface by means of dry cotton cloth. The gloss comes out.

BLS Polymer Coat No.2 - Directions for use

Shake well before use.
Take 4 to 5 drops on U-Foam pad, rub in circular motion on the color surface by hand.By doing same the spiral marks ( swirl marks ) on color surface would remove and the minor scratches reduced by 80% almost.Polymer Coat No.2 would not affect the color density.Set machine at Speed No.4. Buff color surface then cleans the color surface by means of 100% cotton cloth.Under sunlight you can see the spiral (swirl) marks removal.

BLS Polymer Coat No.3 - Directions for use

Shake well before use.
Take 4 to 5 drops on U-Foam pad, apply in circular motion on the color surface by heavy hand. Allow it to dry for a 10 minutes. During this time period apply BLS Polymer Coat No.5. Take 4 to 5 drops on U-Foam pad, spread on fiber, tyre and vinyl surface. After this 10 minutes time period. Set machine at Speed No.4. Buff color surface then cleans the color surface by means of 100% cotton cloth. By doing same, the color surface rapidly reflects the ultra violet radiation which prevents sun fading or color melting.

BLS Polymer Coat No.4 - Directions for use

Take a little (Approx. 1 to 1.5 gm) on a U-Foam pad. Apply uniformly (in circular motion) on the color surface by hand. While applying it looks like a grease which dry rapidly within a 3 to 4 minutes. When completely dry, dull lining comes out. By finger tip method we shall observe the degree of drying, Don’t give excess time for drying.

Make optimum observation then immediately do rubbing by means of Carnuba rubbing cloth –mat surface side to the color surface by light to heavy hand. By doing same, the dull lining goes under pressure and the un-even layer goes to be even layer. More rubbing gives more gloss. Set machine at speed No.4 gets final finishing of color surface.

Note: When you spend more time for drying or exceed 30 minutes and more. you find a hard dull finish layer on the color surface. In such situation you should apply another times by taking a little amount of Coat No. 4 on U-Foam and spread it on color surface with heavy hand the layer breaks into it’s natural state, after that wait for a 2 to 3 minutes and follow as per above user direction the problem will short list.

BLS Polymer Coat No.5 - Directions for use

Shake well before use.
Take 4 to 5 drops on U-Foam pad. Apply to the fiber, tyre and vinyl (mat finish) surfaces. Allow it to dry then buff with a soft cloth. By doing same, enhances resistance to sun fading, prolonging the fiber life, stops absorption of any liquids which prevents splash marks.